[. . . ] Visit the part purchase site and enter the model code of your product to check the parts available for purchase. - You can check the model code and version on the barcode label at the bottom left of For replacement parts, make sure the part name matches that of the illustration in this Following the repair by a non-authorised service provider, self-repair or non-professional repair of the product, Samsung is not liable for any damage to the product, any injury or any other product safety issue caused by any attempt to repair the product which does not carefully follow these repair and maintenance instructions. [. . . ] Open the door and remove the gasket from To replace the gasket Attach a new gasket to the refrigerator door. CAUTION Check that the drawer is inserted properly into the rail during assembly. to remove the drawer Pull the drawers out fully then slightly lift it up to remove the drawers. If the drawers get stuck to door, remove drawer by lifting up after remove shelves. To reattach the drawers Reattaching the drawers follows the reverse order of their respective removal steps. hinge replacement To replace the hinges, you must remove the doors first. When removing the doors, take extreme caution because the doors are heavy. Before replacing the hinges, put a soft pad such as cardboard on the floor to prevent Scratches on the door when you place the doors down. As the hinges must be handled carefully and replaced by two or more persons, we Recommend you to call for professional technical service. If you remove the hinge without holding the door, the door may fall and cause injury. Remove screw 3 ea Cover hinge with the (+) screwdriver and Disconnect wire. Remove the 3 hex bolts that hold the hinge on the top of the refrigerator with the 10mm socket wrench. [. . . ] cAUTION · Make sure the wire connectors are connected properly. Besøg webstedet for køb af reservedele og indtast modelkoden for dit produkt for at Besøk nettstedet for kjøp av deler og legg inn modellkoden til produktet ditt for å For reservedeler må du sørge for at delenavnet samsvarer med illustrasjonen i denne [. . . ]